The pictures on this page are mine. I took them of a Go~Ped I was repairing. If you should want to snatch them for your own personal reference, just do it, no need to ask. Same goes for the written guidance, if printing this whole page out for you or your kids to reference will help you get more out of your Ped, by all means do it.
First loosen the quick release lever. Check so when
the lever is tightened that it takes a fair amount of force to move all the way. If not, tighten the wing
nut on the opposite side until it's a bit difficult
but not impossible to swing the quick release lever
to the lock position. Move the purple detent plate
away from the lower rear fuel tank post. With the
Go-Ped on the ground, jack stand up, place one knee
to the rear of the board on the center line. A little practice and maybe testing with the bathroom scales
is useful here. You want to place 70 to 75 pounds of
weight on the board to create the proper tension on
the tire against the drive spindle.
Go-PedsŪ have become a popular form of recreation and in some cases, transportation. The number one
problem is with rear tire wear. Due to the nature of
the drive system, not all of this wear can be
eliminated but much can be by keeping the rear tire
adjusted correctly. Just remember this, motorized
toys are a form of "motor sports" and this means
maintenance at a higher and more frequent level than
your bowling ball. If you aren't UP to the task, enjoy your bowling.
While applying the correct weight on the board, rotate the purple detent plate to contact the lower rear fuel tank post. If the detent plate is not in contact with the post, bumps encountered while riding will force the tire tighter against the drive spindle. The drive spindle is a bolted on extension of the engine crankshaft. Too much force on the crankshaft will cause a broken shaft or damaged crank bearings. This is a proven engine with very few failures and a damaged crank or crank bearing is almost always due to user failure to properly adjust the tire and set the detent. User failure to properly adjust is not warrantable.
After applying the proper weight and rotating the purple detent lever to contact the fuel tank post, swing the quick release lever to the lock position. It's really about that simple and with practice it only takes a few seconds. The adjustment should be checked everytime fuel is added. Get in a routine to just do it and before long you won't even notice.
Questions? EMAIL me at "NevadaWalrus@WebTV.net"
|